Copley Controls Serial Encoder Uživatelská příručka stáhnout pdf (Strana 143)

Xenus XTL User Guide Using CME 2

Copley Controls Corp. 135

6.5.2.7 Monitor the vector rotation through one electrical cycle for proper Hall transitions.

1 Verify that the red indicator rotates in the same direction as the motor phase angle,

and that the transition occurs when the needle is between indicators (±30 degrees,

as shown below).

2 If the needle and Hall states do not track properly, use the Hall Wiring list box

(shown below) to swap the amplifier’s Hall wire configuration.

3 If the red indicator transition leads or lags behind the centered needle by more than

30 degrees, then try adjusting the Hall Offset in +/- 30 degree increments:

6.5.2.8 Phasing of a motor with encoder and Halls is complete. Click OK.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 179 180

Žádné komentáře

Copley Controls Serial Encoder Uživatelská příručka Strana 143